Dr. Blood Klotz

"Boner" - Mad Dog (2015 - )

"Boner" began life, in 2015, as a simple plastic Skeleton Dog from Home Depot.
Lg LEDs, sourced from Radio Shack, were embedded into his eye sockets,, A servo was attattached to his jaw, then his body was
attached to a pneumatic cylinder. All controlled by a custom programed Arduino controller board.
A motion sensor, attached to the front of the Dog House, activates the routine.

	Dog House made of Polystyrene Boards. Distressed with a hot knife Painted with Latex
	Pneumatic Cylinder, Ardruino Controller
	2022 Version
	Arduino Mega 2650 Controller MP3 Player Board Relay Controller Board Code by Dr. Blood Klotz